English - Messanleitung

Direkt zum Seiteninhalt

Hauptmenü:

English

 
 

Measuring is basically no witchcraft.


Follow exactly the instructions and your coat will fit you perfectly.
Never measure yourself, but be measured by another person !!


 

Neck
Take the circumference in the middle of the neck with a finger in between and add 2 cm. Please note that this is a finished measure and no further dimensional allowances are given.

 

Shoulder Width
Set the shoulder point and mark it for the subsequent measurements. The shoulder point is usually the point in the center of the shoulder ball at the end of the shoulder line. For very strong arms should be 1 till 2 cm addition in the shoulder width. Measure from the left shoulder point across the neck to the right shoulder point.

 

Front shoulder
Measure from the marked left shoulder point to the right shoulder point. Make sure that the measurement is not influenced by the collar.
This measure is used to determine the shoulder position

 

Chest
Measure the breast circumference always over the nipples with two fingers on the inside. Be careful to place the tape horizontally and not too tightly.
Make sure that the arms of the measured person hang loosely and that they are relaxed and breathe.

 

Stomach
Measure the waist circumference at the widest point with two fingers on the inside. Make sure that the tape is horizontal and not tight

 

Hips
Place the measuring tape horizontally at the widest part of the buttocks and leave two fingers on the inside.

 

Biceps
Measure the biceps at the strongest point of the upper arm with a finger space in between. Make sure your arms hang loosely. In the case of a body builder the biceps, by the
Angulation of the arm, if seriously change at this level, 1 to 2 cm can be added.

 

Sleeve length
Measure from the marked shoulder point to the middle finger joint and reduce the measurement by 4 cm.

 

Wrist
Measure the wrist circumference directly through joint bones without finger between. If the customer is wearing a thick watch, the wrist of watch should be added 1-to 2 cm, but only at the customer's request.

 

Adjust the waistline.

This can be done with a belt or similar. This measure is important because here the waist is fixed and it is necessary for the subsequent measurements.
Place the tape around the narrowest part of the waist, this is not exactly noticeable then place the tape on Elbow height horizontally around the waist.
Check with a meter scale if the belt is all around on same level with the ground.

 



Back Waist Length
Make sure that the tape does not slip and measure from the neck along the backline to the waistline of the tape.

 


Front Waist Length
Make sure that the tape has not moved and measure from the top of the shoulder to the the waist line

 

Back waist height
Make sure that the waistband is not slipped and measure from the upper edge of the waistband to the middle of the stomachband.

 

Front waist hight
Make sure that the waistband is not slipped and measure from the upper edge of the waistband to the middle of the stomachband.
The difference front and back should not exceed 19cm. If the difference between the front and the rear is more than 19 cm, please check the belt settings. If it is still bigger after control, give the measure as it is. We clear it in factory.

 

Back Length  / Overcoat Length
Measure from the neck along the backline to where your desiered coats edge.

 

Waistband
Measure the circumference of the waistband on the inside without the waistband directly on body. Measure narrow or wider according to the body shape of the customer.

 

Thigh
Measure the circumference of the thigh at the level of the crotch with one fingers on the inside. Make sure you do not measure too tightly or too far.

 

Crotch
This measure is taken from the top edge of the front waistband by the crotch to the top edge of the rear waistband of the pants. Make sure the trousers remain comfortable in the crotch.

 

Trousers length
Measure from the top edge of thewaistband to the ground and reduce the measurement by 2 cm for a normal length and 3 cm for a short length.
The measure of the pant bottom according to customer requirements. If necessary, measure a fitting trouser.

 

Shoulder slope
To perform this measurement we have a special tool. You can, however, make an estimate based on the graphic in the order data. Another alternative is our measurement service home & office. Please read all the information.

 
 
Zurück zum Seiteninhalt | Zurück zum Hauptmenü